Spent nearly 2 days on this and getting nowhere any help therefore much appreciated
I've an Ultra 6 (firmware 4.2.19) I install the first drive a 3TB Hitachi HDS723030ALA640 it's seen tested and I'm prompted to run Raidar where i define it as X-raid2 all seem to go smoothly.
I then add a second identical drive which I'd have expected to be asigned as redundant. It is seen and tested (very quickly), but when I look at it in Raidar under Volumes I get the following:
Configuration: RAID Level X-RAID2, Single disk
Status: Unprotected. A disk failure will render this volume dead.
Ch 1 : Hitachi HDS723030ALA640 [2794 GB]
2790 GB allocated
Ch 2 : Hitachi HDS723030ALA640 [2794 GB] 2790 GB free
How to I configure the second (available drive) to provide redundancy?