skip to content
This is a sitemap over all available pages ordered by
Can I do the TFTP Boot Recovery from a Mac?
Can I mix disk models and sizes when installing the ReadyNAS?
Can I update the ReadyNAS firmware before installing my disks?
Can I use the disk(s) that were previously used in a PC/MAC?
Does the ReadyNAS support SATA II hard disks?
Boot Related Questions
How can I perform a Boot Recovery using a USB flash device?
How can I properly shutdown the ReadyNAS?
How can I replicate my ReadyNAS settings for a large deployment of systems?
How can I skip the Volume check?
How do I add disks to an existing X-RAID volume?
How do I configure a RAID 1 or RAID 5 volume with a spare disk?
How do I direct-connect between ReadyNAS and PC/Mac?
How do I expand an existing X-RAID volume with larger disks?
How do I install/remove an add-on?
How do I migrate disks over from an existing ReadyNAS to another?
How do I perform a TFTP Boot Recovery?
How do I re-install the firmware?
How do I replace a failed disk?
How do I reset my ReadyNAS admin password?
How do I reset the ReadyNAS to factory default?
How do I switch between Flex-RAID and X-RAID mode?
How do I upgrade the ReadyNAS firmware when the ReadyNAS is not connected to the Internet?
Accessing the Boot Menu
How long does it take to sync a replacement disk?
How many data volumes does the ReadyNAS support in Flex-RAID mode?
How many data volumes does the ReadyNAS support in X-RAID mode?
I've enabled the schedule Power-Off/Power-On option on my NV, but now I cannot power-on my ReadyNAS. What should I do?
I've scheduled auto Power-On, but the ReadyNAS is not powering up automatically?
Is it possible for ReadyNAS to restart when power is restored?
My shares are missing after the ReadyNAS was rebooted. What should I do?
RAIDar is unable to find the ReadyNAS on my network. How do I resolve this?
RAIDar shows ReadyNAS IP is 192.168.168.168 and cannot access NAS, why? and how to fix?
RAIDar status said "Corrupted Root" during factory reset or installation. What should I do?
System boot seems to hang on a bad disk, how do I know which one is bad?
What is the FrontView default login and password after a factory default?
When I used IE7 or Windows Vista, I get security warning. How to get rid of this?
Which models support Jumbo Frames?
Why is my volume capacity is lower than expected?
Will clients with non-jumbo frame network interfaces be able to access the ReadyNAS if jumbo frames is enabled?
Frequently Asked Questions
Welcome to the ReadyNAS.com Wiki
· Last modified: 2012/11/13 20:56 by
Back to top
Except where otherwise noted, content on this wiki is licensed under the following license: